FauxWoodBeams.com, 1 (800) 651-4223  
Subscribe to our
Free Newsletter
 
Live Chat
Shopping cart
Log In
Where's a store?
Contact Us.
Extreme Makeover
American Dream Builders
Our customers say...
"What an amazing product! I can't believe how good this looks!"

Jerry D., Austin, TX

Click to see more testimonials
Visit our other sites

FauxPanels.com
FauxColumns.com
You are at Home Installation Ceiling Systems

Installing Faux Wood Ceiling Panels

PDF Format Download This Page As A Printable PDF

Our ceiling panels and planks are made from a high-density polyurethane material. We lead the industry in creating high-impact panels with extraordinarily realistic dimensional textured surfaces appropriate for indoor or outdoor use. Our ceiling panels and planks do not absorb moisture and will not warp, rot or crack. The following instruction guidelines will help provide the best installation results for your next project.

Storing Ceiling Panels and Planks

Store your ceiling panels or planks flat on a surface in order to avoid 'bowing'. If panels are stored in an upright position and do bow, lay them flat and they will self-correct.

General Installation Guidelines

Our ceiling panels and planks are installed using construction adhesive and screws. However, our ceiling panels and planks may expand and contract with temperature changes and must be installed tightly.

To minimize the effect of expansion and contraction, install the panels as tightly as possible and follow the storage and installation instructions carefully. First, install the ceiling panels or planks on a solid backing. Then run a bead of adhesive along the back of each panel and at each end. Make sure to spread the adhesive with a spackle knife or other appropriate tool. Use enough adhesive so that the entire surface of the cut edge at each end is covered.

We strongly recommend use of construction adhesive and screws (or nails).  All joints should be butt joints on straight runs and mitered joints in corners. Our ceiling panels and planks may require additional shimming and trimming for alignment. Finish seams with color-matched caulk available through us.

Tools You Will Need

Our ceiling panels and planks are easily installed using tools found in almost everyone's toolbox. To complete a wall, we recommend using the following:

1. Galvanized finish nails or screws
2. Construction adhesive
3. Sandpaper or sanding block
4. Caulking gun
5. Colored caulk (to match panel)
6. Any wood cutting saw: circular saw, hacksaw, jig saw, band saw, etc.

 

How To Cover a Ceiling or Wall Using Ceiling Panels or Planks

Start by creating a loose fit by joining pieces on the floor. Check the fit and sand the edges if needed. Use a hacksaw blade if you need to cut to accommodate wall obstructions and sand the edges to smooth. For best results, double-check the fit again. Then apply glue to the backs of the panels and screw into wall using drywall screws. Fit the next panel and glue and screw in place. Repeat until the row is complete. To begin the next row, offset the next row by 1/2 sheet to provide a more seamless effect. For a final finish, use our walnut caulk to fill all screw holes and any gaps - even wide gaps. Smooth the caulk and wipe away any excess (a wet rag works well) and finish the seams to complete the project.

Hot Weather Installation

If panels have been stored under hot conditions, allow panels to cool down to normal temperature before installation.

Cold Weather Installation

If panels have been stored at room temperature or cooler, you may install ceiling panels immediately.

Recommended Adhesive

We recommend our Industrial Strength Adhesive or similar construction adhesive (rated for use on urethane).

Mechanical Fastening

Use either exterior or interior screws, or nails as appropriate for your ceiling panel installation.



How helpful was this page?

  Your rating:
| | | | |
 
Your comments (optional):
Your e-mail (optional):
Please keep me on your monthly newsletter list for product updates, coupons and how-to's (Privacy Policy)

Too hard to read? Click to refresh.
Enter text from picture above:

 

1 (800) 651-4223     Click here to e-mail us.
Follow us on:
Facebook Facebook Facebook Blog houzz interior design ideas
  We Accept:   Guaranteed Security:   Members of:
We Accept

Both credit and debit
Payment Processing
PayPal verified
FauxWoodBeams.com Reviews
Click to verify BBB accreditation and to see a BBB report.
 
0

© 2004—2014 FauxWoodBeams.com™     Terms and Conditions    Privacy Policy